Uninsulated ring terminal suitable for earth leads or battery leads. Crimp and solder your lead for maximum security

Crimp connector takes M8 bolt, flared 5mm diameter cable entry for 16sq.mm / 4mm OD wire

 More than 5 in stock

Oil pressure sender, M12 thread, male bullet connector

Supercedes Guzzi no. 12768700. Some small twins also require adapter 19055800 (or ELA19720 can be fitted in place of this switch). Check which type your small twin uses before replacing.

See ENA12640 for replacement crush washer if required

 More than 5 in stock

 17768750 GU17768750 17 76 87 50
 1776 8750 1776.8750 17.76.87.50

HT lead rubber, used where HT lead screws onto plug cap or pushes onto ignition coil

 More than 5 in stock

 14717600 GU14717600 14 71 76 00
 1471 7600 1471.7600 14.71.76.00

Black NGK spark plug resistor cap with rubbers

Also known as suppressor cap

 More than 5 in stock

LD05F

Weatherproof in-line fuseholder, accepts a standard blade fuse (see ELA00115 or ELA00130)

Ideal for wiring auxiliary equipment like Satnavs, additional lights or fixing the CARC model starting problem with a direct supply from the battery

 4 in stock

Silca key blank for Zadi ignition keys - match profile to your existing key

 3 in stock

ZD9

Reconditioned starter motor and solenoid in black and silver finish. Professionally reconditioned and sold with a 12 month guarantee. This is a suitable replacement for Bosch 8 or 9 tooth Guzzi starter motors. See ELA14738 for replacement solenoid.

This may fit Loop frame models with 5 speed gearboxes, you will need to trim a clearance into the battery tray to make room. The clutch cable bracket will prevent fitment on 4 speed models.

This is an exchange only item, we can supply these before receiving your exchange unit subject to a refundable deposit so you can keep your bike on the road. See ELC10737 for the refundable deposit. Send your old starter motor to our registered address. NB In case of starter motor problems do not tap the casing as this will certainly cause it to fail. See SSA08075 for mounting bolts. Do not remove second nut from terminal posts when fitting - this nut is required to hold the terminal in place

 3 in stock

 14730554 GU14730554 14 73 05 54
 1473 0554 1473.0554 14.73.05.54

6 pin female block connector, used for main loom connections. See ELA30000 for male 6 pin connector

 3 in stock

200073021

Combined LED brake and tail light bulb (21/5W equivalent) for tail lamps. LED bulbs last longer than tungsten (up to 50000 hours), are not affected by vibration and are therefore less likely to leave you exposed on a dark night without a tail light. LED reaction time is also quicker making these a sensible upgrade to your standard bulb

This is a single white LED lamp for tail lights with a red lens. NB Not approved for road use

 3 in stock

Set of Facet points

 2 in stock

 12715445 GU12715445 12 71 54 45
 1271 5445 1271.5445 12.71.54.45